A comparative study between structural properties of pre-tensioned inverted T-girder and actual post-tensioned box girder in bridge construction

作者：Murad Mohammad Omar Faruk^*; Chik Zamri; Mustafa Anwarul; Absar B M Nural; Shikdar Kamal Hossain; Nayan Khairul Anuar Mohd

来源：KSCE Journal of Civil Engineering, 2016, 20(6): 2403-2409.

DOI：10.1007/s12205-016-0657-4

• Inverted T-girder
• Splicing technique
• CSiBridge
• post-tensioned box section
• pre-tensioned inverted T-girder

In this study a full scale 3D analysis of post-tensioned box section and pre-tensioned inverted T-girder section is carried out by considering only vertical loadings. The aim of this research is to investigate long span box Girder Bridge with pre-tensioned inverted T-girder using splicing technique. 4 lanes of 150m long (3 spans @ 50 m) post-tensioned box girder bridge with 12 cells and 13.54 m wide deck is considered as the bridge model and that the equivalent box section consists of 13 numbers of inverted pre-tensioned girder having two different lengths spliced at the points of inflection of continuous length of the bridge. The inverted T-girders are used to support the deck panel with superimposed load on it. The structural analysis of the bridge is done using CSi Bridge employing Integrated 3D Bridge Design Software based on finite element method for both longitudinal and transverse direction. In the analysis, AASHTO LRFD-2006 is used by subjecting Uniformly Distributed Load (UDL), edge loads, knife edge loads, and heavy vehicles load on the bridge deck. Moving vehicles load is placed at different locations to determine the maximum and minimum moments, stresses and flexural effects. Actual post-tensioned box section flexure, shear, torsion and stress in both longitudinal and transverse analyses showed lower values when compared to pre-tensioned inverted T-girder section. Assuming monolithic behaviour, the actual box section provided better stiffness rather than equivalent one. Nevertheless composite behaviour of the equivalent section can be accepted as an alternative solution for long span continuous box Girder Bridge where cost is a major factor in particular.

• 出版日期2016-9