Secondary precipitation during homogenization of Al-Mg-Si alloys: Influence on high temperature flow stress

作者：Oesterreicher Johannes Albert; Kumar Manoj; Schiffl Andreas; Schwarz Sabine; Bourret Gilles Remi^*

来源：Materials Science and Engineering A-Structural Materials Properties Microstructure and Processing, 2017, 687: 175-180.

DOI：10.1016/j.msea.2017.01.074

• Aluminium alloy
• Microstructure
• AA6082
• Homogenization
• Flow stress
• Dispersoids

In the automotive industry Al-Mg-Si alloys are often chosen for high strength extruded profiles. However, the production of such profiles can be challenging for high alloy contents. Among several processing steps, the homogenization heat treatment before extrusion is readily accessible to modifications to improve high temperature formability. In this work, the influence of five different homogenization variants on the flow stress of AA6082 at elevated temperatures was assessed by compression testing in a deformation dilatometer at 450 degrees C, 480 degrees C, and 510 degrees C. The observed differences in flow stress were interpreted with regards to the microstructure. Samples from billets homogenized at higher soak temperatures exhibited lower hot flow stresses in subsequent dilatometer testing, indicating better processability. Since the decrease in flow stress is approximately constant at all test temperatures, it is suggested that it is due to a lower number density of relatively temperature-stable a-Al(Mn,Fe)Si dispersoids formed during homogenization at higher temperatures; these dispersoids are stable at all three test temperatures. In contrast, the influence of a cooling rate variation was relatively minor and diminishes at higher test temperatures since Mg-Si precipitates - whose size and number density is affected by changes of the cooling rate - are less stable at the higher test temperatures.

• 出版日期2017-2-27