The feasibility of converting solid waste into refuse-derived fuel 5 via mechanical biological treatment process

作者：Punin Weera^*; Maneewan Somchai; Punlek Chantana

来源：Journal of Material Cycles and Waste Management, 2014, 16(4): 753-762.

DOI：10.1007/s10163-013-0215-9

• Refuse-derived fuel 5
• Mechanical biological treatment
• Crude oil sludge

The aim of our study was to investigate the feasibility of utilizing solid waste after mechanical biological treatment (MBT) processing at a landfill site in Phitsanulok, Thailand, as refuse-derived fuel 5 (RDF-5). The waste composition, and physical and chemical characteristics of each waste fraction were determined to evaluate the suitability of the waste for recycling and reuse as RDF-5. Results showed that after MBT processing, the solid waste > 40 mm in size was observed to have 33.8 MJ/kg of calorific value. The average concentrations of heavy metals were also found to be within the acceptable limit for plastic waste combustion, thus proving that MBT-processed solid waste > 40 mm in size has high potential for use as RDF-5. The optimal weight ratio of MBT-processed solid waste and crude oil sludge for transformation into RDF-5 was found to be 80:20. With this optimum ratio, the average calorific values of the RDF-5 were determined to be 47 MJ/kg, with sulfur and chlorine contents of 0.16 and 0.74 %, respectively. The characteristics of the produced RDF-5 could meet the specified ASTM standards in terms of calorific value (> 15 MJ/kg), and sulfur and chlorine contents. In addition, the compressive strength of the produced RDF-5 was also found to be suitable for compact storage and transportation without any damage. Finally, the energy production cost from this RDF-5 process was estimated as USD $0.05/kWh.

• 出版日期2014-10