Active vibration control of clamped beams using positive position feedback controllers with moment pair

作者：Shin Changjoo; Hong Chinsuk^*; Jeong Weui Bong

来源：Journal of Mechanical Science and Technology, 2012, 26(3): 731-740.

DOI：10.1007/s12206-011-1233-y

• Active vibration control
• Positive position feedback control
• Non-collocated system
• Open loop transfer function

This paper investigates the active vibration control of clamp beams using positive position feedback (PPF) controllers with a sensor/moment pair actuator. The sensor/moment pair actuator which is the non-collocated configuration leads to instability of the control system when using the direct velocity feedback (DVFB) control. To alleviate the instability problem, a PPF controller is considered in this paper. A parametric study of the control system with PPF controller is first conducted to characterize the effects of the design parameters (gain and damping ratio in this paper) on the stability and performance. The gain of the controller is found to affect only the relative stability. Increasing the damping ratio of the controller slightly improves the stability condition while the performance gets worse. In addition, the higher mode tuned PPF controller affects the system response at the lower modes significantly. Based on the characteristics of PPF controllers, a multi-mode controllable SISO PPF controller is then considered and tuned to different modes (in this case, three lowest modes) numerically and experimentally. The multi-mode PPF controller can be achieved to have a high gain margin. Moreover, it reduces the vibration of the beam significantly. The vibration levels at the tuned modes are reduced by about 11 dB.

• 出版日期2012-3