Numerical modeling of combined low salinity water and carbon dioxide in carbonate cores

作者：Al Shalabi Emad W^*; Sepehrnoori Kamy; Pope Gary

来源：Journal of Petroleum Science and Engineering, 2016, 137: 157-171.

DOI：10.1016/j.petrol.2015.11.021

• Low salinity water injection (LSWI)
• Combined effect of LSWI and CO2
• Fractional flow analysis
• Tertiary recovery factor
• Utilization factor

This paper investigates the combined effect of injecting low salinity water (LSWI) and carbon dioxide (CO2) on oil recovery from carbonate cores. The combined effect of LSWI and CO2 injection on oil recovery was predicted by performing several 1D simulations using measured reservoir rock and fluid data. These simulations included the effect of salinity on both miscible and immiscible continuous gas injection (CGI), simultaneous water-alternating-gas (SWAG), constant water-alternating-gas (WAG), and tapered (WAG). For SWAG and constant and tapered WAG, both seawater and its dilutions were simulated. CO2 was injected above its minimum miscibility pressure. Baker's three-phase relative permeability model was modified to account for the effect of salinity on the water/oil relative permeability.
The results show that SWAG, whether using seawater or its dilutions, outperformed all other tertiary injection modes in terms of oil recovery. Moreover, the SWAG process has both the highest tertiary recovery factor (TRF) and the lowest utilization factor (UF). This study highlights the advantage of using low salinity water along with miscible CO2. The miscible CO2 displaces the residual oil saturation whereas the low salinity water boosts the production rate by increasing the oil relative permeability through wettability alteration towards more a water-wet state. The latter finding was supported by comparing our simulations with the two corefloods reported by Chandrasekhar and Moharny (2014). These corefloods were conducted in SWAG tertiary mode using seawater and its dilutions. Fractional flow analysis shows that SWAG with low salinity water requires less injected solvent compared to SWAG with seawater and miscible CGI.

• 出版日期2016-1