科研之友
微信
新浪微博
Facebook
分享链接
摘要
In this work, azo polymer microspherical cap arrays possessing unique photoprocessible properties have been fabricated through a soft-lithographic contact printing approach. In the process, hexagonal polystyrene (PS) colloidal arrays. obtained by the vertical deposition method, were used as masters. Poly(dimethylsiloxane) (PDMS) stamps with aligned hemisphere air voids on the surfaces were obtained by casting the precursor against the colloidal arrays. By using the stamps and a solution of an epoxy-based azo polymer (BP-AZ-CA) as "ink", the microspherical cap arrays were fabricated by pressing the "inked" surfaces against substrates. Uniform 2D arrays of the submicrometer spherical caps could be obtained on the substrates after peeling off the stamps and drying. The characteristic sizes of the arrays depended on some adjustable features, such as the diameters of PS spheres and concentrations of the "inks" used in the process. After exposure to a linearly polarized Ar(+) laser single beam, the spherical caps could be stretched along the polarization direction, and the arrays were consequently transformed into ellipsoidal cap arrays. Upon irradiation of interfering p-polarized Ar(+) laser beams, only the spherical caps in the bright fringes were deformed by the light irradiation. which resulted in more complicated surface relief patterns. The observation gives another well-defined example of the photoinduced mass migration in the submicrometer scale. The approach can potentially be applied to fabrication of microlens arrays with different converging rate in two directions.
- 出版日期2007-10-23
- 单位清华大学
