A study on diamond grinding wheels with regular grain distribution using additive manufacturing (AM) technology

作者：Yang, Zhibo^*; Zhang, Mingjun; Zhang, Zhen; Liu, Aiju; Yang, RuiYun; Liu, Shian

来源：Materials and Design, 2016, 104: 292-297.

DOI：10.1016/j.matdes.2016.04.104

• Interfacial microstructure
• Diamond grinding wheel
• 3D printing
• Ni-Cr alloy
• Grinding performance

In this paper, a metal bound diamond grinding wheel with a regular grain distribution was fabricated based on 3D printing technology, which provides a solution to the irregular grain distribution and complicated preparation processes of diamond grinding wheels for use in precise/ultraprecise grinding. A grinding wheel was designed in 3D with pro/E, and the data transformation to the stereo-lithography format was carried out. The fabrication of the diamond grinding wheel was achieved with Ni-Cr alloy and diamond by 3D printing and sintering layer by layer. Scanning Electron Microscopy (SEM), Energy Dispersive Spectrometry (EDS) and X-ray diffraction (XRD) were employed to characterize the grains and the micro-structures between the substrate and the Ni-Cr alloy in the diamond grinding wheel, suggesting the infiltration mechanism of Ni-Cr towards the diamond and steel substrate. Finally, the grinding performance was evaluated with an experiment. It was shown that the abrasion of the diamond grinding grains was normal, and no grains fell off the wheel.

• 出版日期2016-8-15
• 单位河南理工大学