Morphology and fracture properties of toughened highly crosslinked epoxy composites: A comparative study between high and low T-g tougheners

作者：Van Velthem P^*; Ballout W; Horion J; Janssens Y A; Destoop V; Pardoen T; Bailly C

来源：Composites Part B: Engineering , 2016, 101: 14-20.

DOI：10.1016/j.compositesb.2016.06.076

• Polymer-matrix composites (PMCs)
• Fracture toughness
• Mechanical properties
• Microstructures
• Prepreg

The mechanical properties of an unmodified reference composite panel based on a highly crosslinked epoxy resin are compared with several corresponding toughened versions, all containing the same amount of representative hard or soft tougheners. The panels are prepared and tested under identical conditions. In terms of tougheners, soft MAM block copolymers and CTBN rubber are compared with two high glass transition temperature (T-g) amorphous thermoplastics, PES and phenoxy. The high T-g thermoplastic tougheners yield considerable improvements of the composites mechanical properties, especially the interlaminar fracture toughness, as compared to the reference panel. On the contrary, MAM and CTBN modification are much less effective. The analysis of the morphology strongly suggests that effective toughening of composite panels based on densely crosslinked epoxy resins requires the combination of at least two key factors: (i) a fine dispersion of the toughener and (ii) strong matrix-toughener and matrix-carbon fibers interfaces. The study provides valuable insights for the choice of suitable tougheners for high performance epoxy systems, based on the link with the physical toughening mechanisms.

• 出版日期2016-9-15