MQL with water in cylindrical plunge grinding of hardened steels using CBN wheels, with and without wheel cleaning by compressed air

作者：Ruzzi Rodrigo de Souza; Belentani Rafael de Mello; de Mello Hamilton Jose; Canarim Rubens Chinali; D'Addona Doriana M; Diniz Anselmo Eduardo; de Aguiar Paulo Roberto^*; Bianchi Eduardo Carlos

来源：International Journal of Advanced Manufacturing Technology, 2017, 90(1-4): 329-338.

DOI：10.1007/s00170-016-9396-4

• Grinding
• Cutting fluids
• MQL
• MQL with water
• Wheel cleaning

Minimum quantity of lubricant (MQL) in grinding is an alternative for reducing abundant fluid flow and both environmental and health hazards when compared with conventional fluid application. In spite of the fact that MQL is considered an innovative cost-effective and environmentally friendly technique, when used in grinding its inadequate application can increase cutting temperature and wheel clogging, worsening surface roughness, and increasing geometric and dimensional errors. The present study aims to evaluate improvements in MQL in grinding using MQL + water (1:1, 1:3, and 1:5 parts of oil per parts of water), when compared to MQL without water and conventional cooling-lubrication technique. Wheel cleaning by compressed air was also tested, aimed for unclogging of the wheel pores. The tests were performed in a plunge cylindrical grinder with CBN wheel and workpieces of AISI 4340 for different feed rates. The ground workpieces were analyzed with respect to the surface roughness, roundness errors, microhardness, and microscopic changes. In addition, tangential cutting force and diametric wheel wear were investigated. The results observed for the MQL plus water in the proportion of 1:5, with wheel cleaning system (at 30A degrees inclination angle of the air nozzle) were the best, when compared to MQL without water, and close to the conventional flood coolant, implying that this technique is a potential alternative for cooling-lubrication when applied properly.

• 出版日期2017-4