Difference in acoustic properties at seismogenic fault along a subduction interface: Application to estimation of effective pressure and fluid pressure ratio

作者：Hashimoto Yoshitaka^*; Doi Noriaki; Tsuji Takeshi

来源：Tectonophysics, 2013, 600: 134-141.

DOI：10.1016/j.tecto.2013.03.016

• Subduction zone
• Accretionary complex
• Seismogenic zone
• Elastic properties
• Fluid pressure

Fluid pressure along subduction plate boundaries plays a role in seismogenesis and tsunami genesis because it is strongly related to the physical properties of faults. In this study, we conducted P-wave velocity (Vp) and S-wave velocity (Vs) measurements for the hanging wall and footwall of a fossil subduction interface with pseudotachylyte located at the northern edge of the Mugi melange in the Cretaceous Shimanto Belt, Shikoku, southwest japan. This area corresponds to the depth of the shallow seismogenic zone in the transition zone between the inner and outer wedges. By combining the acoustic properties with parameters obtained from Amplitude Variation with Offset (AVO) analysis on the Nankai seismic profile, we estimated the fluid pressure at the seismogenic fault.
The Mugi melanges are composed of shale matrices and are juxtaposed with the coherent unit of the Hiwasa formation in the north, which is composed mainly of sandstone. We collected 5 sandstone samples from the hanging wall (Hiwasa formation) and 4 mudstone samples from the footwall (Mugi melange). We conducted velocity measurements while controlling both the fluid pressure and confining pressure by using two pumps. The effective pressure in each measurement ranged from 5 to 65 MPa with intervals of 5 MPa. The Vp and Vs of sandstone increase exponentially with effective pressure from similar to 4500 to similar to 5000 m/s and similar to 2500 to similar to 3000 m/s, respectively. The Vp and Vs of the mudstone also increased exponentially from similar to 4100 to similar to 4500 m/s and similar to 1900 to similar to 2200 m/s, respectively.
We used AVO parameters along the decollement based upon a seismic profile of the Nankai trough, which is off Muroto 40-45 km landward from the trench axis, corresponding to approximately 66 MPa of effective pressure under a hydrostatic condition. By combining the velocities obtained from this study and the AVO parameters derived from the Muroto seismic data, we estimate the mean effective pressures for the hanging wall and the footwall as approximately 10-20 MPa and 8-10 MPa, respectively. The normalized fluid pressure ratios for the hanging wall and the footwall correspond to approximately 0.82-0.91 and 0.91-0.93, respectively. This high fluid pressure indicates a very low effective friction coefficient along the decollement in the transition zone, possibly causing a rupture to propagate to the shallower outer wedge and thus generating a large tsunami.

• 出版日期2013-7-17