A Mixed Wettability Pore Size Distribution Based Mathematical Model for Analyzing Two-Phase Flow in Porous Electrodes II. Model Validation and Analysis of Micro-Structural Parameters

作者：Zhou J; Stanier D; Putz A; Secanell M^*

来源：Journal of the Electrochemical Society, 2017, 164(6): F540-F556.

DOI：10.1149/2.0391706jes

The non-isothermal, two-phase membrane electrodes assembly numerical model previously developed in Part I [J. Electrochem. Soc., 164, 6, F530 (2017)] is validated by comparing to experimentally measured electrochemical performance data under various operating conditions. Water accumulation in catalyst layer (CL) and gas diffusion layer (GDL) are also compared to the neutron and X-ray imaging data and shown to be in agreement. Water fluxes at cathode and anode boundaries and phase change induced flow are analyzed and compared to experimental data. Simulation results indicate that when liquid water is present, reactant transport in the catalyst layer is the key factor limiting fuel cell performance. The model shows that at high relative humidity, 80 degrees C is the optimal operating temperature in order to delay water accumulation without degrading performance due to oxygen dilution by water vapor. The impact of CL and GDL hydrophilic volume fraction, hydrophobic contact angle and pore size distribution on performance are also studied. Results suggest that when liquid water is present, GDL parameters have minimal effect on performance and a CL should have a large hydrophobic contact angle, a low hydrophilic volume fraction, and large pore radius.

• 出版日期2017