Hybrid gel polymer electrolyte fabricated by electrospinning technology for polymer lithium-ion battery

作者：Li, Weili^*; Wu, Yuhui; Wang, Jiawei; Huang, Dong; Chen, Lizhuang; Yang, Gang

来源：European Polymer Journal, 2015, 67: 365-372.

DOI：10.1016/j.eurpolymj.2015.04.014

• Electrospinning technology
• Hybrid gel polymer electrolyte
• Electrochemical performance
• Polymer lithium-ion battery

In this paper, a kind of hybrid gel polymer electrolyte (HGPE) based on PVDF/PEO nanofibrous membrane was prepared by electrospinning technology. The thickness of the nanofibrous membranes was around 150 pm via the controlled procedure parameters. The microstructure of the nanofibrous membranes, the physical and electrochemical performances of the activated HGPEs were studied systematically by scanning electron microscope (SEM), differential scanning calorimetry (DSC), thermal gravimetric analysis (TGA), linear sweep voltammetry (LSV), AC impedance measurement and charge/discharge cycle test, etc. It was found that the properties of the nanofibrous membranes and the corresponding HGPEs varied with the relative weight ratio of the blending polymers. For HGPE, the most important character is its electrochemical performance. When the weight ratio of PVDF/PEO was 1:5, the maximum ionic conductivity of the prepared HGPE was 4.8 x 10(-3) S cm(-1) with electrochemical stability up to 4.8 V versus Li+/Li at room temperature, moreover the assembled polymer lithium-ion battery reserved 86% capacity after 60 cycles of charge and discharge tests. With good electrochemical performance, it is very suitable for being applied in polymer lithium-ion battery.

• 出版日期2015-6
• 单位江苏科技大学; 常熟理工学院