Assessment of combined scale/corrosion inhibitors - A combined jar test/bubble cell

作者：Sanders Laura^*; Hu Xinming; Mavredaki Eleftheria; Eroini Violette; Barker Richard; Neville Anne

来源：Journal of Petroleum Science and Engineering, 2014, 118: 126-139.

DOI：10.1016/j.petrol.2014.04.008

• scale
• corrosion
• combined inhibitors
• calcium carbonate

The formation of calcium carbonate scale and the occurrence of CO2 corrosion are both widespread phenomena observed within pipework during oil and gas production. The most common form of treatment for both processes is the application of chemical inhibition through corrosion and/or scale inhibitors. Surface scaling of pipework rarely occurs in environments where no corrosion exists, yet techniques used to develop and assess the performance of scale inhibitors tend to focus on assessing and reducing solely bulk/surface scaling, without affording consideration towards corrosion, whilst corrosion inhibitors are frequently evaluated in non-scaling environments. Furthermore, both chemicals tend to be evaluated independently meaning that any potential antagonistic effects between the chemicals can go unrecognised.
This paper addresses this very issue by presenting a unique setup and methodology to enable the occurrence of scale and corrosion to be monitored simultaneously in a CO2-saturated environment in the presence and absence of combined scale and corrosion inhibitors. The test cell focuses on evaluating four key parameters which are quantified either throughout the duration of the test, or from the implementation of post-test surface analysis techniques.
The multiple assessment of (i) bulk scale precipitation, (ii) surface scaling, (iii) general corrosion and (iv) localised corrosion permits a full assessment of the chemical blends propensity to mitigate both scaling and corrosion. Non-inhibited tests were initially conducted at 60 degrees C to form a baseline for comparison. Four combined scale/corrosion inhibitors were subsequently used at low concentrations in order to understand their mechanisms and highlight any competitive effect which existed in reducing either scale or corrosion. The results demonstrate that the methodology implemented is effective at assessing the efficiency of combined inhibitors in reducing both corrosion and scale in environments where both processes occur simultaneously. The limitations of conducting solely bulk scaling or corrosion tests in non-scaling environments are discussed relative to the results obtained in this work. The results of each individual inhibitor are discussed and markedly different behaviour is observed according to the concentration administered, as well as the particular blend of chemicals applied.

• 出版日期2014-6