A+25-dBm IIP3 1.7-2.1-GHz FDD Receiver Front End With Integrated Hybrid Transformer in 28-nm CMOS

作者：Fabiano Ivan; Ramella Matteo; Manstretta Danilo^*; Castello Rinaldo

来源：IEEE Transactions on Microwave Theory and Techniques, 2017, 65(11): 4677-4688.

DOI：10.1109/TMTT.2017.2742480

• Blocker tolerant
• cellular communications
• current mode
• direct conversion
• duplexers
• 5G
• frequency-division duplexing (FDD)
• isolation
• local thermal equilibrium (LTE)
• low power
• surface acoustic wave (SAW)-less
• 3G
• tunable circuits

A highly linear receiver (RX) front end with integrated hybrid transformer (HT) for frequency-division duplexing mobile communications is reported. The HT, implemented with a three-winding coplanar transformer, is used to interface the RX front end with the antenna and the power amplifier. The primary is driven at its center tap with the transmitted signal and at one input with the antenna signal, while the other input is connected to an on-chip programmable balancing impedance. The two secondary drives a differential push-pull common-gate low-noise amplifier (LNA). Assuming a perfectly linear hybrid only 45 dB of transmitter (TX)-RX isolation and 35 dB of common-mode rejection are required to meet the intermodulation specs thanks to the +25-dBm receiver IIP3. This would drastically simplify hybrid balancing and adaptation loop. Cascaded noise figure of duplexer, LNA, and baseband is below 6.7 dB and TX insertion loss below 4.3 dB from 1.7 to 2.1 GHz. The implemented prototype in 28-nm CMOS has an active area of 0.7 mm(2) and requires only 26 mW.

• 出版日期2017-11