Mechanical and Microstructural Characterization of Nodular Cast Iron (NCI) with Niobium Additions

作者：Fonseca Souza Tania Nogueira; Perilo Sousa Nogueira Rogeria Alves; Saldanha Franco Francis Jose; Paulino Aguilar Maria Teresa; Cetlin Paulo Roberto

来源：Materials Research, 2014, 17(5): 1167-1172.

DOI：10.1590/1516-1439.249413

• Nodular Cast Iron (NCI)
• Niobium
• microstructure
• mechanical properties

Nodular cast irons (NCIs) involve the inoculation and nodulization of 0.03 to 0.06wt% Magnesium, as well as the addition of Molybdenum, Chromium, Nickel, Copper and Vanadium, although the presence of Niobium is not common. The literature reports that Niobium leads to better mechanical properties of the NCIs, and recent results indicate that 0.5wt% Niobium increases the strength and the Charpy notch toughness of NCIs, but decreases its hardness, in relation to a similar NCI without Niobium. The present report studies the addition of 0.23, 0.47, 0.67, and 0.85wt% Niobium to a NCI covering the effects on the microstructures, yield and tensile strengths, tensile elongations and Charpy toughness. The NCIs were prepared in a 120 kg medium frequency induction furnace, and samples were obtained following the ASTM A842 standard; the various test specimens were extracted from these samples according to specific standards for each test. Fracture analysis was performed in fractures specimens after the Charpy tests. It was shown that the volume fraction of pearlite increases as the Niobium content is raised, leading to increments in the yield and tensile strengths and hardness of these materials. Modest increment of tensile ductility and Charpy toughness are observed only for an addition of 0.23% Niobium. Fracture analysis revealed typical brittle cleavage surfaces and decohesion between grains and grain - graphite nodules interfaces, and very low porosity

• 出版日期2014-10