Nanoflake CoN as a high capacity anode for Li-ion batteries

作者：Das B; Reddy M V; Malar P; Osipowicz Thomas; Rao G V Subba; Chowdari B V R^*

来源：Solid State Ionics, 2009, 180(17-19): 1061-1068.

DOI：10.1016/j.ssi.2009.05.007

• CoN
• Thin films
• Electrochemical behavior
• Anodes
• Li-ion batteries

CoN films with nanoflake morphology are prepared by RF magnetron sputtering on Cu and oxidized Si substrates and characterized by X-ray diffraction (XRD), field-emission scanning electron microscopy (FE-SEM), high resolution transmission electron microscopy (HR-TEM) and selected area electron diffraction (SAED) techniques. The thickness and composition of the films are determined by the Rutherford back scattering (RBS) technique confirming the stoichiometric composition of CoN with a thickness, 200 (+/- 10) nm. Li-storage and cycling behavior of nanoflake CoN have been evaluated by galvanostatic discharge-charge cycling and cyclic voltammetry (CV) in cells with Li-metal as counter electrode in the range of 0.005-3.0 Vat ambient temperature. Results show that a first-cycle reversible capacity of 760 (+/- 10) mAhg(-1) at a current rate 250 mAg(-1) (0.33 C) increases consistently to yield a capacity of 990 (+/- 10) mAhg(-1) after 80 cycles. The latter value corresponds to 2.7 mol of cyclable Li/mol of CoN vs. the theoretical, 3.0 mol of Li. Very good rate capability is shown when cycled at 0.59 C (up to 80 cycles) and at 6.6 C (up to 50 cycles). The coloumbic efficiency is found to be 96-98% in the range of 10-80 cycles. The average charge and discharge potentials are 0.7 and 0.2 V, respectively for the decomposition/formation of Li(3)N as determined by CV. However, cycling to an upper cut-off voltage of 3.0 V is essential for the completion of the "conversion reaction". Based on the ex-situ-XRD, -HR-TEM and -SAED data, the plausible Li-cycling mechanism is discussed. The results show that nanoflake CoN film is a prospective anode material for Li-ion batteries.

• 出版日期2009-7-16