Determination of three-dimensional quantities related to scalar dissipation rate and its transport from two-dimensional measurements: Direct Numerical Simulation based validation

作者：Chakraborty N; Kolla H^*; Sankaran R; Hawkes E R; Chen J H; Swaminathan N

来源：Proceedings of the Combustion Institute, 2013, 34(1): 1151-1162.

DOI：10.1016/j.proci.2012.06.040

• Scalar dissipation rate (SDR)
• Two-dimensional experimental measurements
• Direct Numerical Simulation
• Isotropy
• Reynolds-Averaged Navier-Stokes (RANS) simulation

Three-dimensional compressible Direct Numerical Simulation (DNS) data of freely propagating statistically planar and statistically stationary slot-jet turbulent premixed flames has been used to assess the accuracy of the isotropy-derived correction factors, which relate the two-dimensional projections of the different terms of the Favre-averaged scalar dissipation rate transport equation with their corresponding actual three-dimensional counterparts. The accuracy of these correction factors is assessed using both simplified and detailed chemistry-based DNS data, for a range of values of Karlovitz number Ka, heat release parameter tau, and turbulent Reynolds number Re-t. It is shown that the isotropic distribution of the probability density pdf) of the angle, phi, between the normal vectors of the measurement plane and of the flame surface provides a simple algebraic relation between the scalar dissipation rates evaluated in two and three dimensions (i.e. (N) over tilde (c) and (N) over tilde (2D)(c)), independent of the considered values of Ka, tau and Re-t. The isotropic relations between two-dimensional and three-dimensional counterparts of the curvature and propagation terms in the transport equation of (N) over tilde (c) are also found to work well for all the values of Ka, tau and Re-t considered here. However, the relation between the value obtained from two-dimensional projection and the true three-dimensional value for the strain rate term in the (N) over tilde (c) transport equation works well only for large values of Re-t and the reasons for this behaviour are explained in detail. It is found that the threshold value of Ret above which the assumption of isotropy yields an accurate relation between two-dimensional projection and three-dimensional values for the strain rate term of the dissipation rate transport equation depends on the regime of the prevailing combustion process.

• 出版日期2013