科研之友
微信
新浪微博
Facebook
分享链接
摘要
A 852 nm ridge waveguide edge emitting laser has important applications. But lateral mode instability leads to its poor beam quality because of its ridge structure. Such a structure gives rise to two guidance mechanisms (gain-guide and index-guide), whose change leads to "kink" effect. So, the control of the single fundamental lateral mode is more difficult. There is no well-informed study in these aspects for ridge waveguide edge emitting lasers. In this paper we study how to improve the beam quality for achieving a stable fundamental lateral mode output experimentally. We are to investigate the influence of lateral mode characteristics of the laser with different ridge depth-to-width ratios in detail by waveguide theory and equivalent refractive index method. Depth and width of the ridge are two key parameters influencing lateral mode. The depth can control lateral guidance mechanism, and the width can control lateral mode order. We find that the ratio must be in a limited range to ensure the single fundamental lateral mode steady. Through theoretical analysis of waveguide theory and equivalent refractive index method, we obtain a limited range of depth-to-width ratio. Then we conduct an experimental comparison, where we adjust the ridge depth, with the width fixed, to control the ratio. Meanwhile we improve the fabrication technology to ensure the accuracy of the structure. We design and fabricate an asymmetric waveguide ridge waveguide edge emitting laser with isolation grooves, whose active region is the core of asymmetric waveguide epitaxy structure. The key structural parameters are 5 mu m in ridge width, 500 nm in ridge depth, 2 mu m in isolation grooves depth, 10 mu m in width, 30 mu m in spacing between the grooves, and 1 mm in cavity length. Isolation grooves are very useful for improving the performance of the laser: threshold decreased by 50%, output power raised by 44%, and slop efficiency increased by 17%. And the equally crucial role of grooves is to avoid being damaged at packaging process to maintain laser structure. Finally we achieve a stable single fundamental lateral mode output and an accurate tuning wavelength at 852 nm of ridge waveguide edge emitting laser without cavity surface coated at working current 150 mA, working temperature 30 degrees C (working conditions can be changed in a small range). The slope efficiency is on average 0.7 mW/mA (its maximum value is 0.89 mW/mA), and the full wave at half maximum is less than 1 nm. Although we improve the performance of ridge waveguide edge emitting laser and beam quality for stable output, there is still a need to further study the stable output over a wide range. The results in this paper will provide a useful reference for realizing the stable output ridge waveguide edge emitting lasers and the ultra-narrow line-width lasers.
- 出版日期2017-4-20
- 单位北京工业大学
