A Correction to the Stress-Strain Curve During Multistage Hot Deformation of 7150 Aluminum Alloy Using Instantaneous Friction Factors

作者：Jiang, Fulin; Tang, Jie; Fu, Dinfa^*; Huang, Jianping; Zhang, Hui

来源：Journal of Materials Engineering and Performance, 2018, 27(6): 3083-3090.

DOI：10.1007/s11665-018-3375-x

• 7150 aluminum alloy
• flow stress correction
• instantaneous friction factor
• multistage hot deformation
• physical simulation

Multistage stress-strain curve correction based on an instantaneous friction factor was studied for axisymmetric uniaxial hot compression of 7150 aluminum alloy. Experimental friction factors were calculated based on continuous isothermal axisymmetric uniaxial compression tests at various deformation parameters. Then, an instantaneous friction factor equation was fitted by mathematic analysis. After verification by comparing single-pass flow stress correction with traditional average friction factor correction, the instantaneous friction factor equation was applied to correct multistage stress-strain curves. The corrected results were reasonable and validated by multistage relative softening calculations. This research provides a broad potential for implementing axisymmetric uniaxial compression in multistage physical simulations and friction optimization in finite element analysis.

• 出版日期2018-6
• 单位湖南大学