ECAP process improvement based on the design of rational inclined punch shapes for the acute- angled Segal 2 theta-dies: CFD 2-D description of dead zone reduction

作者：Perig A V; Golodenko N N

来源：Mechanical Sciences, 2015, 6(1): 41-49.

DOI：10.5194/ms-6-41-2015

<jats:p>&lt;p&gt;&lt;strong&gt;Abstract.&lt;/strong&gt; This article is focused on a 2-D fluid dynamics description of punch shape geometry improvement for Equal Channel Angular Extrusion (ECAE) or Equal Channel Angular Pressing (ECAP) of viscous incompressible continuum through acute-angled Segal 2θ-dies with 2θ &lt; 90°. It has been shown both experimentally with physical simulation and theoretically with computational fluid dynamics that for the best efficiency under the stated conditions, the geometric condition required is for the taper angle 2&amp;amp;theta;&lt;sub&gt;0&lt;/sub&gt; of the inclined oblique punch to be equal to the 2&amp;amp;theta; angle between the inlet and outlet channels of the Segal 2θ-die. Experimentally and theoretically determined rational geometric condition for the ECAP punch shape is especially prominent and significant for ECAP through the acute angled Segal 2θ-dies. With the application of Navier-Stokes equations in curl transfer form it has been shown that for the stated conditions, the introduction of an oblique inclined 2&amp;amp;theta;&lt;sub&gt;0&lt;/sub&gt;-punch results in dead zone area downsizing and macroscopic rotation reduction during ECAP of a viscous incompressible continuum. The derived results can be significant when applied to the improvement of ECAP processing of both metal and polymer materials through Segal 2&amp;amp;theta;-dies.&lt;/p&gt;
</jats:p>

• 出版日期2015