Microstructure analysis and low-cycle fatigue behavior of spray-formed Al-Li alloy 2195 extruded plate

作者：Zhang, Qingyou; Zhang, Cunsheng^*; Lin, Jun; Zhao, Guoqun; Chen, Liang; Zhang, Hao

来源：Materials Science and Engineering A-Structural Materials Properties Microstructure and Processing, 2019, 742: 773-787.

DOI：10.1016/j.msea.2018.11.053

• Spray-formed Al-Li alloy
• Low-cycle fatigue
• Fatigue life
• Fracture morphology
• Deformation microstructure

Microstructure and low-cycle fatigue behavior of spray-formed Al-Li alloy 2195 extruded plate were investigated in this work. The spray-formed alloy after hot extrusion experiment was treated with solid solution treatment and artificial aging. Microstructure analysis indicated the aged plate was dominated by elongated unrecrystallized grains, and had a rolling-type texture along extrusion direction with the highest intensity at Brass component. The existence of T-1 phase strengthened the alloy crucially, but delta' phase was basically absent. Then, the fully-reversed strain-controlled low-cycle fatigue tests were conducted at total strain amplitudes ranging from 0.4% to 1.0% for samples along two orthogonal directions. The stress-strain hysteresis loops were acquired, and the cyclic stress response curves were derived. At low strain amplitudes (0.4-0.5%), the initial cyclic hardening was slight and followed by a cyclic stability, while at higher strain amplitudes (0.6-1.0%), the alloy merely presented a continuously increasing cycle hardening behavior. Moreover, the fatigue life model based on the total strain energy was built and found to be suitable to predict life. Finally, the fatigue fracto-graphy observation showed that the fatigue source is relatively concentrated and the fracture surface had typical fatigue striations at 0.5% strain amplitude, while multiple cracks originated on the sample surface and the final fracture zone showed a ductile characteristic at 1.0%. The deformed microstructure near fracture surfaces were observed, and it was found that the cyclic hardening and stability were closely associated with the interaction between moving dislocations and obstacles including (sub)grain boundaries and secondary phase particles against them.

• 出版日期2019-1-10
• 单位山东大学