科研之友
微信
新浪微博
Facebook
分享链接
摘要
In order to better utilize the residual polymers formed after polymer flooding, the distribution and the presence of the polymers after polymer flooding were studied. This paper studied the vertical and plane distribution of the hydrophobically-associating polymer in addition to measuring the parameters after polymer flooding, which is important for numerical reservoir simulation. The results showed that the polymers mainly enter into the high permeability zone and distribute in the mainstream line area with only a small portion in the wing area. Based on the comparison of various experimental methods, double-slug experiments were chosen to measure the inaccessible pore volume and retention, which is considered to be the most accurate, most time-consuming and most complex method. Following this, we improved the processing method of experimental data by reducing it to one experiment with two parameters. At the same time, we further enhanced the accuracy of the experimental results. The results show that at 1750 mg/L, the inaccessible pore volume of the polymer is 25.8%. When the detention is 68.2 mu g/g, the inaccessible pore volume constituted 22% of the total polymer, with the other 77.7% being the dissolved polymer. Moreover, the static adsorption and dynamic detention were measured, with the results showing that the static adsorption is larger than dynamic detention. Therefore, in the numerical reservoir simulation, using the static adsorption capacity instead of the dynamic detention is unreasonable. The double-slug method was chosen since it is more accurate for the determination of various parameters. Meanwhile, in order to enhance the accuracy of results, we improved the treatment of data.
- 出版日期2017-12
- 单位中国地质大学（北京）
