科研之友
微信
新浪微博
Facebook
分享链接
摘要
The indirect (Brazilian) tensile strength test is commonly used in rock engineering and rock mechanics. Most of the research on how to interpret Brazilian test is only valid for isotropic rock. The load may be applied to disc shaped samples through flat platens or curved jaws and the different load configurations give rise to subtle but important differences to stress distributions throughout samples during testing and at the onset of failure. To reliably obtain the tensile strength accurate stress distributions, especially at the location of the initial crack, must be determined. However, most real rocks exhibit a certain type of anisotropy known as transverse isotropy due to the presence of preferred directions of grains, beddings, microcracks or pores. This study focuses on the failure modes when transverse isotropy is present. Previous studies for transverse isotropy indicate that the exact location of the initial crack is at the disc centre. These studies, however, ignore the effect of the load contact configuration on the stress distribution. This paper overcomes this limitation and applies Amadei's analytical solution to assess the effects of the load contact area on the stress distribution. The stress distribution is coupled with a transverse isotropy failure criterion in a mechanically consistent way to find the exact location of initial crack. It is shown that the location of the initial crack depends on the transverse isotropy orientation and load configuration.
- 出版日期2017
- 单位水利工程仿真与安全国家重点实验室; 天津大学
