Numerical simulation of fluid flow and solidification in continuous slab casting mould based on inverse heat transfer calculation

作者：Chen, R.^*; Shen, H. F.; Liu, B. C.

来源：Ironmaking and Steelmaking, 2011, 38(7): 546-551.

DOI：10.1179/1743281211Y.0000000049

• Continuous slab casting
• Mould
• Fluid flow
• Heat transfer
• Inverse problem

A mathematical model based on an inverse heat transfer calculation was built to determine the heat flux between the mould and slab based on the measured mould temperatures. With K-epsilon turbulence model, a mathematical model of three-dimensional heat transfer and solidification of molten steel in continuous slab casting mould is developed. Solidification has been taken into consideration, and flow in the mushy zone is modelled according to Darcy's law as is the case of flow in the porous media. The heat flux prescribed on the boundaries is obtained in the inverse heat conduction calculation; thus, the effect of heat transfer in the mould has been taken into consideration. Results show that the calculated values of mould temperature coincide with the measured ones. Results also reveal that the temperature distribution and shell thickness are affected by the fluid flow and heat transfer of slab which is governed by the heat flux on the mould/slab interface.

• 出版日期2011-10
• 单位清华大学