科研之友
微信
新浪微博
Facebook
分享链接
摘要
Object. The porcine spine is widely used as an alternative to the human spine for both in vivo and in vitro spinal biomechanical studies because of the limited availability and high cost of human specimens. The aim of this study was to develop a reproducible in vitro osteoporotic vertebral model for spinal implant investigations.
Methods. Four mature domestic porcine lumbar spines (L1-5) were obtained. An in vitro decalcification method was used to decrease the mineral content of the porcine vertebrae, with Ca-chelating agents (0.5 M EDTA solution, pH 7.4) that altered the bone mineral density (BMD). Lumbar-spine area BMD was evaluated using dual-energy x-ray absorptiometry; spine volumetric BMD and spine geometry were assessed by central quantitative CT scanning to monitor the time it took the decalcification process to induce the WHO-defined standard of osteoporosis. Micro computed topography provided information on the 3D microarchitecture of the lumbar vertebrae before and after decalcification with EDTA. Hematoxylin and eosin staining of lumbar vertebrae was performed. Both the control (5 specimens) and osteoporotic vertebrae (5 specimens) were biomechanically tested to measure compressive strength.
Results. The differences in area BMD measurements before and after the demineralizing processes were statistically significant (p < 0.001). The results of the compression test before and after the demineralizing processes were also statistically significant (p < 0.001).
Conclusions. The data imply that the acid demineralizing process may be useful for producing a vertebra that has some biomechanical properties that are consistent with osteoporosis in humans. (DOI: 10.3171/2010.12.SPINE10453)
- 出版日期2011-6
- 单位长春大学
