Dualism of precipitation morphology in high strength low alloy steel

作者：Chen Chih Yuan^*; Chen Chien Chon; Yang Jer Ren

来源：Materials Science and Engineering A-Structural Materials Properties Microstructure and Processing, 2015, 626: 74-79.

DOI：10.1016/j.msea.2014.12.029

• Precipitation
• Ti-Mo
• Nano-sized carbide

While the role of microalloying elements on precipitation strengthening in ferrite matrix during austenite/ferrite transformation is quite clear, some uncertainty still exists concerning the variability of the microhardness distribution of ferrite grains in the isothermal holding condition. The objective of the present study was to clarify the intrinsic characteristics of carbide precipitation morphology in the ferrite matrix under different processing temperatures and times and to correlate it with austenite decomposition kinetics to elucidate why a large microhardness distribution occurs at low isothermal holding temperature. Better understanding of carbide precipitation behavior can help researchers to determine the root cause of variation in microhardness distribution, which would allow metallurgists to produce high quality steels. Measurement with a Vickers hardness indenter revealed that, in specimens isothermally held at 625 degrees C, the range of Vickers hardness distribution was 240-420 after 5 min of isothermal holding, and 270-340 after 60 min. For specimens isothermally held at 725 degrees C, the range of Vickers hardness distribution was 200-330 for 5 min of isothermal holding, and 200-250 for 60 min. Therefore, the average microhardness decreased with the isothermal holding temperature and time, and a larger range of distribution occurred with short isothermal holding times.
Transmission electron microscopy (TEM) images showed that interface precipitation and random precipitation can occur within the same ferrite grain. The reason is that the austenite decomposition rate varies with transformation temperature and time. An excessively fast austenite/ferrite interface movement velocity, which usually happens in small ferrite grains, would cause these ferrite grains with microalloying elements to exceed their solubility. Furthermore, these microalloying elements will be precipitated randomly after isothermal holding at longer times. Consequently, a large microhardness distribution can usually be detected in specimens with tiny ferrites because some ferrite grains are in a fresh state, without carbides, due to high austenite/ferrite interface movement velocities. Furthermore, one important technological limit that should be kept in mind is the difficulty of developing only one type of precipitation morphology (i.e., interface precipitation or random precipitation) within every ferrite grain.

• 出版日期2015-2-25