科研之友
微信
新浪微博
Facebook
分享链接
摘要
The grinding wheel generally has a complicated topography for the irregularity of abrasive grits, which always has an important influence on the final quality of the grinding workpiece. In this paper, a joint method of microscopic observation and grindable thermocouple technique was adopted to model the wheel topography. The grinding wheel topography was first modeled through microscopic observation by an in-position 3D microscope KH-7700 installed on the grinding machine. Based on the measurement of grit sizes, shapes, and distributions through the 3D microscope, a wheel surface model was established and a static grit number model based on Rayleigh distribution was proposed. Moreover, a numerical model was given to validate the proposed Rayleigh distribution model of an active grit number. In order to investigate the real abrasive grit number in a grinding process, an embedded grindable thermocouple was used to detect the dynamic variation of temperature signals, which will reflect the variation of in-process wheel topography under different process parameters, machine status, and even the grit-workpiece interaction status. Through the experimental analysis, it can be concluded that the increase of depth of cut a (p) could help to greatly increase the active grit number to the grinding process, while the increase of workpiece speed V (w) and decrease of wheel speed V (s) could lead to a subtle increase of the grit number. Moreover, the active grit number is about one fourth to one third of the static grits. The contact arc length between the wheel (CBN) and the workpiece (Ti-6Al-4V) was calculated by the contact time from the workpiece surface temperature data, and it was found that the actual contact arc length was about 1.5 similar to 2 times of the geometric size.
- 出版日期2018-7
- 单位东华大学
