Processing and performance of 2D fused-silica fiber reinforced porous Si3N4 matrix composites

作者：Han Guifang^*; Zhang Litong; Cheng Laifei

来源：Journal of University of Science and Technology Beijing, 2008, 15(1): 58-61.

DOI：10.1016/S1005-8850(08)60012-2

• porous matrix composites
• fused-silica fiber
• Si3N4
• mechanical behavior
• dielectric constant

Two-dimension (2D) fused-silica fiber reinforced porous silicon nitride matrix composites were fabricated using slurry impregnation and cyclic infiltration with colloidal silica sol. The microstructure and fracture surface were characterized by SEM, the mechanical behavior was investigated by three-point bending test, and the dielectric constant was also measured by impedance analysis. The microstructure showed that the fiber and the matrix had a physical bonding, forming a clearance interface. The mechanical behavior suggested that the porous matrix acted as crack deflection, and the fracture surface had a lot of fiber pull-out. However, the interlaminar shear strength was not so good. The dielectric constant of the composites at room temperature was about 2.8-3.1. The relatively low dielectric constant and non-catastrophic failure indicated the potential application in the radome materials field.

• 出版日期2008-2
• 单位西北工业大学