A 200-W permanent magnet Hall thruster discharge with graphite channel wall

作者：Ding, Yongjie; Li, Hong; Sun, Hezhi; Wei, Liqiu^*; Jia, Boyang; Su, Hongbo; Peng, Wuji; Li, Peng; Yu, Daren

来源：Physics Letters, Section A: General, Atomic and Solid State Physics , 2018, 382(42-43): 3079-3082.

DOI：10.1016/j.physleta.2018.08.017

• Hall thruster
• Permanent magnet
• Graphite channel wall

A 200-W Hall thruster was designed using permanent magnets placing the axial maximum magnetic field outside of the channel, and the anode/gas distributor as an integrated U-shaped structure. A split structure is adopted for the discharge channel to conveniently change the wall material. With the initial conditions that the anode mass flow is maintained at 0.8 mg/s, 1.0 mg/s and 1.2 mg/s over a voltage range of 150-400 V (at 50 V intervals), the discharge properties were determined for the two thruster models with the channel walls composed of graphite and boron nitride (BN). The results demonstrate that under identical operating parameters, the properties of the thruster with the graphite channel walls are similar to the properties of the thruster with the BN channel walls. The maximum difference of the discharge current between the two wall materials is 6.2%; the maximum difference of the thrust and the specific impulse is 3.3%, and that of the anode efficiency is 1.7% (absolute value). These differences are smaller than the corresponding parameter differences observed from changing wall materials in other common Hall thrusters.

• 出版日期2018-10-26
• 单位哈尔滨工业大学