Analysis on profile accuracy for ultrasonic machining of alumina ceramics

作者：Lalchhuanvela H^*; Doloi B; Bhattacharyya B

来源：International Journal of Advanced Manufacturing Technology, 2013, 67(5-8): 1683-1691.

DOI：10.1007/s00170-012-4601-6

• Ultrasonic machining
• Hexagonal hole
• Hole profile
• Process parameters
• Ceramics

Ultrasonic machining (USM) is a mechanical material removal process which has great potential for machining hard and brittle materials such as ceramics, semiconductors, glasses, etc. The accuracy of the job profile generated by USM can be improved by optimal control of the process parameters. This paper presents the study on the influences of ultrasonic machining process parameters such as abrasive grit size, slurry concentration, power rating, tool feed rate and slurry flow rate on generated hexagonal hole profile. The angular deviations at corner angles, dimensional deviations across flat surfaces and dimensional deviation across corners of the hexagonal hole profile have been studied. Based on experimental results, the influences of abrasive grit size, slurry concentration, power rating and tool feed rate were analysed. From the analysis of parametric influences based on various test results, the best parametric combination was found as grit number of 600, slurry concentration of 30 %, power rating of 50 % and feed rate of 1.08 mm/min for achieving better profile accuracy during machining of Al2O3 ceramics. The experimental investigations carried out for determining the influence of USM process parameters will provide effective guideline to select parametric settings for achieving desired job profile accuracy on non-circular holes during ultrasonic drilling of alumina.

• 出版日期2013-7