Adsorption of Methylene Blue by ultrasonic surface modified chitin

作者：Dotto G L; Santos J M N; Rodrigues I L; Rosa R; Pavan F A; Lima E C

来源：Journal of Colloid and Interface Science, 2015, 446: 133-140.

DOI：10.1016/j.jcis.2015.01.046

• Cationic dye
• Chitin
• Surface modification
• Thermodynamic
• Ultrasound

Hypothesis: chitin is a biopolymer which can be used as a low-cost and eco-friendly material for dyes adsorption. The use of chitin for dyes removal is little investigated, due its low surface area, porosity and high crystallinity. So, an ultrasonic surface modified chitin (USM-chitin) was prepared and used for Methylene Blue (MB) adsorption.
Experiments: Chitin was obtained from shrimp wastes and its surface was modified by an ultrasound-assisted treatment. USM-chitin was characterized by N-2 adsorption/desorption isotherms (BET surface area, total pore volume), infrared spectroscopy, X-ray diffraction and scanning electron microscopy. The adsorption of MB on USM-chitin was studied by kinetic, equilibrium, thermodynamic, interactions analysis, desorption and mass transfer aspects.
Findings: USM-chitin presented surface area 25 times higher than raw chitin. The porosity was increased and the crystallinity was decreased. The general order model was suitable to represent the adsorption kinetics and the Langmuir model was adequate for the equilibrium. The maximum adsorption capacity was 26.69 mg g(-1). The adsorption was spontaneous, favorable and exothermic. USM-chitin can be used seven times maintaining the same adsorption capacity. Published by Elsevier Inc.

• 出版日期2015-5-15