A Fully Integrated Built-In Self-Test Sigma-Delta ADC Based on the Modified Controlled Sine-Wave Fitting Procedure

作者：Hong Hao Chiao^*; Su Fang Yi; Hung Shao Feng

来源：IEEE Transactions on Instrumentation and Measurement, 2010, 59(9): 2334-2344.

DOI：10.1109/TIM.2009.2034582

• Analog-to-digital conversion (ADC)
• built-in self-test (BIST)
• design for testability
• integrated circuit testing
• mixed analog-digital integrated circuits
• Sigma-Delta modulation

This paper demonstrates the first fully integrated built-in self-test (BIST) Sigma-Delta analog-to-digital converter (ADC) chip to the best of our knowledge. The ADC under test (AUT) comprises a second-order design-for-digital-testability Sigma-Delta modulator and a decimation filter. The purely digital BIST circuitry conducts single-tone tests for the signal-to-noise-and-distortion ratio (SNDR), the dynamic range, the offset, and the gain error of the AUT. The BIST design is based on the proposed modified controlled sine-wave fitting procedure to address the component overload issues, reduce the setup parameter numbers, and eliminate the need for parallel multipliers. The total gate count of the whole BIST circuitry is only 13 300. The hardware overhead is much less than the BIST design using the traditional fast Fourier transform (FFT) analysis. Measurement results show that the peak SNDR results of the proposed BIST design and the conventional FFT analysis are 75.5 and 75.3 dB, respectively. The subtle SNDR difference is already within analog test uncertainty. The BIST Sigma-Delta ADC achieves a digital test bandwidth higher than 17 kHz, very close to the rated 20-kHz bandwidth of the AUT.

• 出版日期2010-9-10