A contribution to the study of negative polarity in GMA welding

作者：Li Peigang; Hurtig Kjell; Hogstrom Mats; Svensson Lars-Erik; Scotti Americo^*

来源：International Journal of Advanced Manufacturing Technology, 2018, 95(5-8): 2543-2553.

DOI：10.1007/s00170-017-1349-z

• Welding
• Production
• GMAW
• Negative polarity
• Fusion rate
• Weld bead geometry

Gas metal arc welding (GMAW) using the electrode with negative polarity (DCEN) has been frequently suggested as a potential means of increasing production capacity. The objective of this work was to further study the performance of negative polarity in GMAW of carbon steels. In this project phase, bead-on-plate welds were carried out in flat position to assess the effect of different potential shielding gas compositions on bead geometry, finishing and spattering. The characteristics were compared with DCEP at the same current, but depositing the same volume of material per unit of length (more industrial related comparison). The arc length was kept the same by adjusting voltage to reach shortest arcs, yet with suitable non short-circuiting metal transfer mode. An approach to measure bead convexity was also proposed and assessed. The results showed that DCEN is feasible as a means of increasing GMAW production capacity. However, to become DCEN applicable with GMAW, the results suggest an Ar-based blend with around 6.5% of O-2 is the most appropriate shielding gas, as much as that there is a demand for a standard electronic controlled power source able to work in constant current mode.

• 出版日期2018-3