A numerical investigation of new film cooling hole configuration at the leading edge of asymmetrical turbine blade: part A

作者：Benabed Mustapha^*

来源：Heat and Mass Transfer, 2013, 49(4): 497-508.

DOI：10.1007/s00231-012-1096-5

The focus of the first part of this numerical study is to investigate the effects of two new configurations: (1) slot with cylindrical end and (2) slot with median cylindrical hole, generated by the combination between two film cooling configurations: cylindrical hole and uniform slot. Computational results are presented for a row of coolant injection holes on each side of an asymmetrical turbine blade model near the leading edge. For each configuration, three values of the radius are taken: R = 0.4, R = 0.8 and R = 1.2. The six cases simulations, thus obtained, are conducted for the same density ratio of 1.0 and the same inlet plenum pressure. A new parameter, Rc, is defined to measure the rate of blade coverage by the film cooling. Results show that, at the pressure side; for the two new configurations, the six studied cases exceed the case baseline in cooling effectiveness term with the best result obtained for R = 0.8 (case 2). For the suction side, only configurations with R = 0.4 (cases 1 and 4) provide an increase of film effectiveness compared to the case baseline. The following configuration: Cases 1 or 4 at the suction side and case 2 at the pressure side, gets the best thermal protection because of their higher coverage and strong cooling effectiveness.

• 出版日期2013-4