Development of a flexible three-axis tactile sensor based on screen-printed carbon nanotube-polymer composite

作者：Pyo Soonjae^*; Lee Jae Ik; Kim Min Ook; Chung Taeyoung; Oh Yongkeun; Lim Soo Chul; Park Joonah; Kim Jongbaeg

来源：Journal of Micromechanics and Microengineering, 2014, 24(7): 075012.

DOI：10.1088/0960-1317/24/7/075012

• carbon nanotube-polymer composite
• tactile sensor
• piezoresistive
• flexibility
• screen printing

A flexible, three-axis carbon nanotube (CNT)-polymer composite-based tactile sensor is presented. The proposed sensor consists of a flexible substrate, four sensing cells, and a bump structure. A CNT-polydimethylsiloxane (PDMS) composite is produced by a solvent evaporation method, and thus, the CNTs are well-dispersed within the PDMS matrix. The composite is directly patterned onto a flexible substrate using a screen printing technique to fabricate a sensor with four sensing cells. When a force is applied on the bump, the magnitude and direction of force could be detected by comparing the changes in electrical resistance of each sensing cell caused by the piezoresistive effect of the composite. The experimentally verified sensing characteristics of the fabricated sensor exhibit a linear relationship between the resistance change and the applied force, and the measured sensitivities of the sensor for the normal and shear forces are 6.67 and 86.7%/N for forces up to 2.0 and 0.5 N, respectively. Experiments to verify the load-sensing repeatability show a maximum 2.00% deviation of the resistance change within the tested force range.

• 出版日期2014-7