Drinking water treatment sludge as an efficient adsorbent for heavy metals removal

作者：Abo El Enein S A; Shebl Ahmed^*; El Dahab S A Abo

来源：Applied Clay Science, 2017, 146: 343-349.

DOI：10.1016/j.clay.2017.06.027

• Drinking water treatment sludge
• Lead cadmium nickel removals
• Adsorption
• Quartz
• Illite
• Albite

Green chemists paid much more attention towards the alternative ways to reutilize waste materials instead of its disposal in a non-ecofriendly manner. In this study, drinking-water treatment sludge (DWTS), which is a by-product resulted from drinking water treatment plants, was successfully applied as an adsorbent for Pb(II), Cd(II) and Ni(II) removal from wastewater. The physicochemical characteristics of DWTS were investigated using X-ray diffraction (XRD), X-ray fluorescence (XRF), scanning electron microscopy (SEM) and N-2 adsorption-desorption isotherms.
The XRD analysis revealed that the DWTS under study consists of quartz and illite phases which had been reported for their adsorption efficiency. Firing of DWTS at 500 degrees C causes the appearance of albite phase in addition to previous ones which enhances the adsorption capacity of these materials. The influence of different parameters such as firing temperature of DWTS, contact time, pH, DWTS dose and initial metal ions concentration on the adsorption of heavy metal ions and, consequently, on their removal were investigated. DWTS exhibit an adsorption efficiency towards Pb(II) > Cd(II) > Ni(II). The extremely high efficiency of DWTS towards Pb(ll) adsorption can nominate it as a specific low-cost adsorbent for Pb ions.

• 出版日期2017-9-15