Novel chemoresistive CH4 sensor with 10 ppm sensitivity based on multiwalled carbon nanotubes functionalized with SnO2 nanocrystals

作者：Humayun Md Tanim; Divan Ralu; Liu Yuzi; Gundel Lara; Solomon Paul A; Paprotny Igor^*

来源：Journal of Vacuum Science and Technology A: Vacuum, Surfaces and Films , 2016, 34(1): 01A131.

DOI：10.1116/1.4936384

Chemoresistive sensors based on multiwalled carbon nanotubes (MWCNTs) functionalized with SnO2 nanocrystals (NCs) have great potential for detecting trace gases at low concentrations (single ppm levels) at room temperature, because the SnO2 nanocrystals act as active sites for the chemisorption of gas molecules, and carbon nanotubes (CNTs) act as an excellent current carrying platform, allowing the adsorption of gas on SnO2 to modulate the resistance of the CNTs. However, uniform conjugation of SnO2 NCs with MWCNTs is challenging. An effective atomic layer deposition based approach to functionalize the surface of MWCNTs with SnO2 NCs, resulting in a novel CH4 sensor with 10 ppm sensitivity, is presented in this paper. Scanning electron microscopy, transmission electron microscopy (TEM), energy dispersive x-ray spectroscopy, and Raman spectroscopy were implemented to study the morphology, elemental composition, and the crystal quality of SnO2 functionalized MWCNTs. High resolution TEM images showed that the crystal quality of the functionalizing SnO2 NCs was of high quality with clear lattice fringes and the dimension almost three times smaller than shown thus far in literature. A lift-off based photolithography technique comprising bilayer photoresists was optimized to fabricate SnO2 functionalized MWCNTs-based chemoresistor sensor, which at room temperature can reliably sense below 10 ppm of CH4 in air. Such low level gas sensitivity, with significant reversible relative resistance change, is believed to be the direct result of the successful functionalization of the MWCNT surface by SnO2 NCs.

• 出版日期2016-1