Nanomechanical characterization of alumina coatings grown on FeCrAl alloy by thermal oxidation

作者：Frutos E^*; Gonzalez Carrasco J L; Polcar T

来源：Journal of the Mechanical Behavior of Biomedical Materials, 2016, 57: 310-320.

DOI：10.1016/j.jmbbm.2016.01.027

• Nano-indentation
• Repetitive-nano-impact test
• High strain rate test
• Dynamic hardness
• Fracture toughness
• Alumina coatings

This work studies the feasibility of using repetitive-nano-impact tests with a cube-corner tip and low loads for obtaining quantitative fracture toughness values in thin and brittle coatings. For this purpose, it will be assumed that the impacts are able to produce a cracking, similar to the pattern developed for the classical fracture toughness tests in bulk materials, and therefore, from the crack developed in the repetitive impacts it will be possible to evaluate the suitability of the classical indentation models (Anstins and Laugier) for measuring fracture toughness. However, the length of this crack has to be lower than 10% of the total coating thickness to avoid substrate contributions. For this reason, and in order to ensure a small plastic region localized at the origin of the crack tip, low load values (or small distance between the indenter tip and the surface) have to be used. In order to demonstrate the validity of this technique, repetitive-nano-impact will be done in a fine and dense oxide layer (alpha-Al2O3), which has been developed on the top of oxide dispersion strengthened (ODS) FeCrAl alloys (PM 2000) by thermal oxidation at elevated temperatures. Moreover, it will be shown how it is possible to know with each new impact the crack geometry evolution from Palmqvist crack to half-penny crack, being able to study the proper evolution of the different values of fracture toughness in terms of both indentation models and as a function of the strain rate, (epsilon) over dot, decreasing. Thereby, fracture toughness values for alpha-Al2O3 layer decrease from similar to 4.40 MPa root m, for high epsilon value (10(3) s(-1)), to similar to 3.21MPa root m, for quasi-static (epsilon) over dot value (10(-3) s(-1)). On the other hand, epsilon a new process to obtain fracture toughness values will be analysed, when the classical indentation models are not met. These values are typically found in the literature for bulk alpha-Al2O3, demonstrating the use of repetitive-nano-impact tests which not only provide qualitative information about fracture resistance of the materials but it also can be used to obtain quantitative information as fracture toughness values in the case of brittle materials.

• 出版日期2016-4