A 4 Gb/s 3-bit Parallel Transmitter With the Crosstalk-Induced Jitter Compensation Using TX Data Timing Control

作者：Jung Hae Kang^*; Lee Kyoungho; Kim Jong Sam; Lee Jae Jin; Sim Jae Yoon; Park Hong June

来源：IEEE Journal of Solid-State Circuits, 2009, 44(11): 2891-2900.

DOI：10.1109/JSSC.2009.2028917

• Crosstalk
• crosstalk-induced jitter
• data timing control
• inductive coupling
• capacitive coupling
• microstrip
• signal mode
• transmitter
• wireline

By using the data timing control at the transmitter (TX), the crosstalk-induced jitter (CIJ) is compensated for in the 3-bit parallel data transmission through the coupled microstrip lines on printed circuit board (PCB). The difference in propagation velocity with the signal modes (odd, static, even) is compensated for by sending data earlier or later at TX according to the signal modes, so that the signals of different modes arrive at receiver at the same time. The proposed TX was implemented by using a 0.18 mu m CMOS process. The measurement shows that the proposed TX reduces the RX jitters by about 30 ps (more than 50% of the added jitter due to CIJ and ISI) at the data rates from 2.6 Gb/s to 4.0 Gb/s. The proposed scheme can be applied to more than three parallel microstrip lines.

• 出版日期2009-11