Molecular orientation and miscibility of fluorinated alpha,omega-alkanediol and alcohol at the hexane/water interface

作者:Murakami Daiki*; Fukuda Tsubasa; Matsubara Hiroki; Aratono Makoto; Takiue Takanori
来源:Colloids and Surfaces A: Physicochemical and Engineering Aspects , 2010, 354(1-3): 205-209.
DOI:10.1016/j.colsurfa.2009.08.024

摘要

The interfacial tension gamma of the hexane solution of 1H,1H,10H,10H-perfluorodecane-1,10-diol (FC(10)diol) and 1H,1H,2H,2H-perfluorododecanol (TFC12OH) mixture against water was measured as a function of the total molality in and composition of TFC12OH in the mixture X-2 at 298.15 K under atmospheric pressure. The interfacial pressure pi vs. mean area per adsorbed molecule A curves and the phase diagram of adsorption (PDA) were constructed in order to shed light on the effect of the molecular orientation on the state of and the miscibility of FC(10)diol and TFC12OH in the adsorbed film. The pi vs.A curves demonstrated that the mixed system exhibits three kinds of film states, parallel-condensed, normal-condensed, and multilayer states, depending on m and X-2. The PDA indicated that film composition X-2(H) in the parallel-condensed state never exceeds 0.14 even when X-2 is increased to 0.9. This limited miscibility is probably due to a microphase separation that FC(10)diol and TFC12OH molecules are not dispersed molecularly but the parallel-condensed domains of FC(10)diol and the normal-condensed domains of TFC12OH are mixed at the interface. In the normal-condensed state, on the other hand, the FC(10)diol molecules may stand upright and be mixed with TFC12OH molecules. The multilayer is much richer in FC(10)diol than in TFC12OH when the multilayer is evolved from the parallel-condensed monolayer below X-2 = 0.9, while the fraction of TFC12OH increases very rapidly when it is evolved from the normal-condensed monolayer H above X-2=0.925. Below X-2=0.9, the X-2(H) value in the multilayer is similar to that in the parallel-condensed monolayer. Thus it is plausible that FC(10)diol molecules are preferentially piled with parallel orientation in the upper layer of the multilayer. Above X-2 = 0.925, the multilayer may not be homogeneous but heterogeneous in thickness. These views were confirmed from the X-2 dependence of molality m(i)(eq) of each component at the phase transition points.

  • 出版日期2010-2-5