科研之友
微信
新浪微博
Facebook
分享链接
摘要
In this paper, we have developed a rapid prototyping process using hybrid master molds for hot-embossing lithography. The hybrid master mold developed here typically consists of a structural layer of SU-8, an overlayer of copper, and a top layer of antistick compound. The structure is first formed by the negative photoresist SU-8 layer with conventional photolithography. On the structural SU-8 layer, a nanoscale copper thin film is deposited to enhance the mechanical strength of the mold and improve heat transfer during the hot-embossing process. Finally, an outermost antistick layer is formed by the reaction of trichloro-(1H,1H,2H,2H-perfluoroctyl)-silane with the oxidized copper surface. These three layers cooperatively yield a hybrid mold which can be fabricated on a silicon wafer or any other suitable substrates for subsequent hot-embossing lithography. Our tests have verified that the molds fabricated with this method do not show any degradation of their structural design features and surface smoothness after 30 hot-embossing cycles. In comparison to other methods of making master molds for hot-embossing lithography such as laser machining and electroplating, the present method is simple and fast, with no reliance on any additional replication steps and fabrication procedures. Hence, the present method can remarkably reduce cost and the processing time in hot embossing, which is particularly attractive in prototyping or small volume production.
- 出版日期2012-8
- 单位中国工程物理研究院
