Adhesion of Explosives

作者：Chaffee Cipich Michelle N; Sturtevant Bryce D; Beaudoin Stephen P^*

来源：Analytical Chemistry, 2013, 85(11): 5358-5366.

DOI：10.1021/ac302758n

It is of increasing importance to understand how explosive particles adhere to surfaces in order to understand how to remove them for detection in airport or other security settings. In this study, adhesion forces between royal demolition explosive (cyclotrimethylenetrinitramine) (RDX), pentaerythritol tetranitrate (PETN), and trinitrotoluene (TNT) in their crystalline forms and aluminum coupons with three finishes, acrylic melamine (clear coating), polyester acrylic melamine (white coating) automotive finishes, and a green military-grade finish, were measured and modeled. The force measurements were performed using the atomic force microscopy (AFM)-based colloidal probe microscopy (CPM) method. Explosive particles were mounted on AFM cantilevers and repeatedly brought in and out of contact with the surfaces of interest while the required force needed to pull out of contact was recorded. An existing Matlab-based simulator was used to describe the observed adhesion force distributions, with excellent agreement. In these simulations, the measured topographies of the interacting surfaces were considered, although the geometries were approximated. The simulations were performed using a van der Waals force-based adhesion model and a composite effective Hamaker constant. It was determined that certain combinations of roughness on the interacting surfaces led to preferred particle-substrate orientations that produced extreme adhesion forces.

• 出版日期2013-6-4