A 7/24-GHz CMOS VCO With High Band Ratio Using a Current-Source Switching Topology

作者：Wang Sen^*; Xiao Chang Yuan

来源：IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2016, 63(5): 790-795.

DOI：10.1109/TUFFC.2016.2536702

• Band ratio
• CMOS
• Colpitts
• cross-coupled pair (CCP)
• voltage-controlled oscillator (VCO)

In this paper, a 7/24-GHz dual-band voltage-controlled oscillator (DVCO) using a current-source switching topology is designed, implemented, and verified in a 0.18-mu m CMOS technology for C-band and K-band radar applications. The low-and high-frequency bands are obtained by the Colpitts mode oscillation and the cross-coupled pairs (CCPs) mode oscillation, respectively. Unlike conventional dual-band VCOs realized by resonator-switching topologies, the proposed VCO is based on the composite Colpitts and CCP architecture to avoid additional losses in the resonator, or lower its power consumption. The fabricated VCO occupies a chip area of 0.95 x 0.71 mm(2) including all testing pads. Measurements show that the VCO operating in the Colpitts mode provides a phase noise of -112.5 dBc/Hz at 1 MHz offset from the 7.4-GHz oscillation frequency under 7.5-mW power consumption. When the VCO is operating in the CCP mode, it provides a phase noise of -99.9 dBc/Hz at 1 MHz offset from the 24-GHz oscillation frequency with 9.7-mW power dissipation. Moreover, the DVCO achieves a high band ratio (f(H)/f(L) = 24/7) of 3.43. To the authors' best knowledge, the design features the highest band ratio, low power dissipation, and comparable electrical performances among previously reported DVCOs.

• 出版日期2016-5