Bond behaviour of GFRP bars in high-strength concrete: bar diameter effect

作者：Lee Jung Yoon; Lim A Ra; Kim Jinyoung; Kim Jeongho

来源：Magazine of Concrete Research, 2017, 69(11): 541-554.

DOI：10.1680/jmacr.15.00403

• compressive strength
• pull-out testing
• testing
• structural elements

The effects of reinforcing bar diameter and concrete compressive strength on the bond behaviour of glass fibre reinforced polymer (GFRP) bars were investigated. The primary experimental parameters were the type of reinforcing bar (steel, sand-coated GFRP and spiral-wrapped GFRP), the concrete compressive strength (20, 40 and 60 MPa) and the bar diameter (19 and 25 mm). The experimental results revealed that as bar diameter increases, the bond strength of the GFRP bars decreases at a greater rate than that of the steel bars. The bond strength was found to decrease linearly with increasing bar diameter for the GFRP bars while, for the steel bars, the bond strength decreased with increasing bar diameter up to 19 mm and then became constant thereafter. For high-strength concrete, a lower reduction rate in bond strength was observed with increasing bar diameter. It is postulated that an increase in concrete compressive strength causes internal interface (fibre-resin) failure of GFRP bars, while an increased bar diameter results in external interface (resin-concrete) failure.

• 出版日期2017-6