科研之友
微信
新浪微博
Facebook
分享链接
摘要
The compositional variation of clinopyroxene and the partitioning of major elements between clinopyroxene and melt are estimated as a function of the cooling rate. Clinopyroxenes were crystallized under variable cooling regimes (15, 9.4, 3, 2.1, and 0.5 degrees C/min from 1250 down to 1000 degrees C) and at isothermal conditions of 1000 degrees C from a basaltic composition at a pressure of 500 MPa under anhydrous and hydrous (H(2)O = 1.3 wt.%) conditions. The clinopyroxene chemistry shows that, as the cooling rate increases, crystals are progressively depleted in Ca, Mg, Fe(2+) and Si and enriched in Na, Fe(3+), Al (mainly Al(IV)), and Ti, Di and Hd versus CaTs and CaFeTs form a continuous binary solid solution characterized by higher amounts of tschermakitic components with increasing cooling rate. Two parameters (DH = Di + Hd and TE = CaTs + CaFeTs + En) are calculated to describe the effect of cooling rate on the clinopyroxene composition. The variation of DH/TE with increasing cooling rate evidences the kinetic process induced by rapid cooling in basic rocks under hydrous and anhydrous conditions. Dynamic crystallization conditions affect the partitioning of major elements between clinopyroxene and melt; with increasing cooling rate, the value of crystal-melt partition coefficient departs from that obtained at the isothermal condition. However, in spite of these variations, the values of (cpx-melt)Kd(Fe-Me) remain almost constant. Therefore, the Fe(2)-Mg exchange between clinopyroxene and melt is not suitable to prove the (dis)equilibrium conditions in basaltic cooling magmas, giving rise to possible mismatches in the application of thermobarometers. The results of our study are consistent with that observed at the margin of dikes or in the exterior portions of lavas, where the cooling rate is maximized and disequilibrium compositions of clinopyroxene have been found.
- 出版日期2010-8
