All Active MMIC-Based Wireless Communication at 220 GHz

作者：Kallfass Ingmar^*; Antes Jochen; Schneider Thomas; Kurz Fabian; Lopez Diaz Daniel; Diebold Sebastian; Massler Hermann; Leuther Arnulf; Tessmann Axel

来源：IEEE Transactions on Terahertz Science and Technology, 2011, 1(2): 477-487.

DOI：10.1109/TTHZ.2011.2160021

• Millimeter-wave amplification
• millimeter-wave FET integrated circuits
• millimeter-wave frequency conversion
• millimeter-wave monolithic integrated circuits (MMICs)
• wireless communication
• 220 GHz

A wireless data link operating at a carrier frequency of 220 GHz is supporting a data rate of up to 25 Gbit/s in on-off-keyed PRBS as well as complex 256-QAM (quadrature amplitude modulation) transmission. The millimeter-wave transmit and receive frontends consist of active multi-functional millimeter-wave microwave integrated circuits (MMICs), realized in 50 nm mHEMT technology and packaged into split-block waveguide modules. The paper presents system considerations for wireless links in the 200-300-GHz range, discusses the design and performance of dedicated broadband transmit and receive MMICs, and presents link experiments. With an RF transmit power of -3.4-1.4 dBm in the IF frequency range from 0 to 20 GHz, a receiver conversion gain of better than -4.8 dB up to 270 GHz and an estimated noise figure of less than 7.5 dB at 220 GHz, a 2(31) - 1 PRBS with a data rate of up to 25 Gbit/s is transmitted over 50 cm and received with an eye diagram quality factor >3. At 10 Gbit/s, an uncorrected bit-error rate (BER) of 1.6 . 10(-9) is measured over a distance of 2 m. A 256-QAM signal with approx. 14 Mbit/s is received with an uncorrected BER of 9.1 . 10(-4).

• 出版日期2011-11