科研之友
微信
新浪微博
Facebook
分享链接
摘要
We report the fabrication of 3D micro coils made with an automatic wire bonder. Using standard MEMS processes such as spin coating and UV lithography on silicon and Pyrex (R) wafers results in high aspect ratio SU-8 posts with diameters down to 100 mu m that serve as mechanical stabilization yokes for the coils. The wire bonder is employed to wind 25 mu m insulated gold wire around the posts in an arbitrary (e. g. solenoidal) path, yielding arrays of micro coils. Each micro coil is bonded directly on-chip, so that loose wire ends are avoided and, compared to other winding methods, coil re-soldering is unnecessary. The manufacturing time for a single coil is about 200 ms, and although the process is serial, it is batch fabrication compatible due to the high throughput of the machine. Despite the speed of manufacture we obtain high manufacturing precision and reliability. The micro air-core solenoids show an RF quality factor of over 50 when tested at 400 MHz. We present a flexible coil making method where the number of windings is only limited by the post height. The coil diameter is restricted by limits defined by lithography and the mechanical strength of the posts. Based on this technique we present coils ranging from 100 mu m diameter and 1 winding up to 1000 mu m diameter and 20 windings.
- 出版日期2010-1
