科研之友
微信
新浪微博
Facebook
分享链接
摘要
The effects of film flow rate, heat flux, inlet liquid temperature, tube diameter and liquid distributor height on subcooled falling film heat transfer outside a horizontal smooth tube are numerically studied, and a heat transfer correlation based on the current data is developed. Comparisons between the predicted results and the published experimental data in the literature are also conducted. The calculation ranges are: film flow rate from 0.025 to 0.284 kg m(-1) s(-1), heat flux from 1.0 to 100 kW m(-2), inlet liquid temperature from 2 to 104 degrees C, tube diameter from 6.35 to 50.8 mm and liquid distributor height from 3.0 to 50.8 mm. The results indicate that: (1) the numerical results of the local heat transfer coefficient are in good agreement with the experimental data in the literature; (2) the surface tension plays an important role in the calculations of heat transfer in two stagnation zones, (3) the heat transfer coefficient shows four distinct zones along with peripheral angle: stagnation zone, impingement zone, thermal layer development zone and departure zone; (4) the heat transfer coefficient increases with increase in film flow rate, tube diameter or liquid distributor height, while keeps constant with increasing heat flux; (5) the correlation predicts 92% of the total 141 calculated data with deviations within +/- 10%, and predicts 78% of 284 data available in literature with deviations within +/- 30%.
