Ultrafine particle emissions from desktop 3D printers

作者：Stephens Brent^*; Azimi Parham; El Orch Zeineb; Ramos Tiffanie

来源：Atmospheric Environment, 2013, 79: 334-339.

DOI：10.1016/j.atmosenv.2013.06.050

• Indoor aerosols
• Three-dimensional printers
• Thermoplastic emission
• Molten extrusion deposition

The development of low-cost desktop versions of three-dimensional (3D) printers has made these devices widely accessible for rapid prototyping and small-scale manufacturing in home and office settings. Many desktop 3D printers rely on heated thermoplastic extrusion and deposition, which is a process that has been shown to have significant aerosol emissions in industrial environments. However, we are not aware of any data on particle emissions from commercially available desktop 3D printers. Therefore, we report on measurements of size-resolved and total ultrafine particle (UFP) concentrations resulting from the operation of two types of commercially available desktop 3D printers inside a commercial office space. We also estimate size-resolved (11.5 nm-116 nm) and total UFP (%26lt;100 nm) emission rates and compare them to emission rates from other desktop devices and indoor activities known to emit fine and ultrafine particles. Estimates of emission rates of total UFPs were large, ranging from similar to 2.0 x 10(10) # min(-1) for a 3D printer utilizing a polylactic acid (PLA) feedstock to similar to 1.9 x 10(11) # min(-1) for the same type of 3D printer utilizing a higher temperature acrylonitrile butadiene styrene (ABS) thermoplastic feedstock. Because most of these devices are currently sold as standalone devices without any exhaust ventilation or filtration accessories, results herein suggest caution should be used when operating in inadequately ventilated or unfiltered indoor environments. Additionally, these results suggest that more controlled experiments should be conducted to more fundamentally evaluate particle emissions from a wider arrange of desktop 3D printers.

• 出版日期2013-11