Direct Carbon Fuel Cell Operation on Brown Coal with a Ni-GDC-YSZ Anode

作者：Rady Adam C; Giddey Sarbjit; Kulkarni Aniruddha; Badwal Sukhvinder P S^*; Bhattacharya Sankar

来源：Electrochimica Acta, 2015, 178: 721-731.

DOI：10.1016/j.electacta.2015.08.064

• Fuel cell
• DCFC
• Brown coal
• ceria
• zirconia

Char products derived from brown coal from Morwell in the Latrobe Valley, Australia, were tested in a solid electrolyte based Direct Carbon Fuel Cell (DCFC) at 850 degrees C. Electrolyte supported button cells were used with a Ni-GDC (gadolinia doped ceria) anode with 15 wt% YSZ (yttria stabilised zirconia) for thermal stability and better adhesion with the YSZ electrolyte. The cell performed well under N-2 when using demineralised Morwell char as the fuel, generating reproducible V-j and P-j curves and sustaining chronopotentiometric loading of 20 mA cm(-2) for 2 hours with no appreciable signs of voltage decay. Operation with raw Morwell char initially achieved comparable peak power densities to that of the demineralised char, however, subsequent runs with raw Morwell char exhibited decreasing power densities and signs of diffusion-limitations at higher current densities. Ash deposition at the anode is proposed as a possible differentiator of extended cell operability between the two fuels. In addition to fuel-based performance of the DCFC, the response of the anode and system as a whole was closely monitored using Electrochemical Impedance Spectroscopy. Introduction of CO2 into the anode chamber instead of N-2 enhanced cell performance and longevity of cell operation under sustained loading. An increase in the ohmic resistance component with increasing current density was observed for Ni-GDC-YSZ anode in N-2 atmosphere, but not in H-2 atmosphere and it has been attributed to the oxidation of Ni near the electrode/electrolyte interface during current passage and lack of sufficient reducing species to keep Ni in its reduced state.

• 出版日期2015-10-1
• 单位CSIRO